Jump to content

Ford C-Max hybrid 2013 trouble codes


hpl90
 Share

Recommended Posts

Hi I buy car from USA and I have problems with trouble codes can someome help me what's this codes means? Sory for my english imnnot from USA :) here is a list of codes: P26CA P26D0 U019F P1408 P05A1-00 P26CA-00 P26D0-00 P26D3-00 UO19F-00 P1408 P1703 thansk for help

Link to comment
Share on other sites

Search the attached  document for P26CA, P26D0, P26D3 and U019F all relating to the cooling system.

 

 

P1703 - Brake Switch Out of Self Test Range

Description: 

This DTC sets when, during the key ON engine OFF (KOEO) self-test, the brake pedal position (BPP) switch signal was high, or during the key ON, engine running (KOER) self-test, the BPP signal did not cycle high and low. Possible Causes:
  • BPP circuit open
  • BPP circuit short to ground
  • BPP circuit short to voltage
  • Stoplamp circuits open
  • Stoplamp circuits short to ground
  • Stoplamp circuits short to voltage
  • Concern in module connected to the BPP circuit
  • Damaged brake switch
  • Incorrectly adjusted brake switch 

P1408 - EGR Flow Out Of Self Test Range

Description: This test is carried out during the key ON, engine running (KOER) self-test only. The exhaust gas recirculation (EGR) system is commanded on at a fixed engine speed. This DTC sets when the PCM detects the EGR flow is less than or greater than expected. Possible Causes:
  • Electric exhaust gas recirculation (EEGR) valve stuck open or closed
  • EEGR connector not seated correctly
  • EEGR stepper motor
  • VPWR circuit open
  • EGRMC circuit open
  • EGRMC circuit short to voltage
  • EGRMC circuit short to ground
  • Vacuum signal to manifold absolute pressure (MAP) restricted or leaking
  • Mass airflow (MAF) sensor signal erroneous
  • Carbon build up in the EEGR valve seat area 

 P05A1 - Grille Shutter A Minimum/Maximum Stop Performance

Description:   Possible Causes:   Diagnostic Aids: Refer to the Workshop Manual Section 501-02, Front End Body Panels to continue diagnosis. Application   Key On Engine Off Key On Engine Running Continuous Memory All   Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. 
 
 
 
Link to comment
Share on other sites

P05A1 Active Grille Air Shutter "A" Position Sensor Minimum / Maximum Stop Performance

 

When the grille shutter actuator senses it is unable to obtain a fully open or closed position of the grille shutter, it sends a message to the PCM via the LIN . The PCM then sets the DTC when the fault is communicated for a predetermined amount of time. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...