Hello everyone, Just finished hooking up a rear cam to the lockpick in my c-max. As others have mentioned - running the video wire can be tedious - I used an RG6 wire w/ RCA heads as my camera didn't come w/ an RCA video cable. The major issue w/ my install is that the camera is a license plate model - and it blocks finger access to the hatch release. I have placed an order for the same camera as @dumbcomputers and also the LED light - I will replace the licence plate rig once it comes in (and seal the hole I drilled behind the license plate!). Btw, @dumbcomputers - any suggestions on how to route the video/powercables from this camera - do you have to take the license light/trunk handle piece off? if so how do you do this.. Some notes: 1. I did tap into +/- power from the LH side reverse light vs running power all the way back to the lockpick - seems to work fine - camera fires right up when I hit reverse. 2. after noting all the 12V issues in various threads - I wanted to ensure the lockpick did not constantly draw power - it seems to light up a red/green light when it is on - and it sees to click and turn off a few seconds after the ignition is off and interior lights go out - I cannot be 100% sure that it is not drawing power other than the audible click and LED light going off. Of course once you put the dash back together - it is not possible to see the lockpick's light. 3. Since I will have a free license plate camera - I was thinking about mounting it on the front - I did temporarily wire the video to the front port of the lockpick - it fired up just fine. I am considering using the 2.4ghz video transmitter rigs for the front side so as not to have to punch holes in the firewall. Any suggestions on what to tap for power on the front side? 4. While installing, I did take some pictures and can post them if folks are interested. Thanks moe k