Search the Community

Hey guy's I'm a in a bit of a dilemma. So one of my rear motor mounts bolts snapped in the transmission housing and thought it would just be easier to replace the housing part #(DG9P-7976-CC). While pulling the housing I accidently pulled the Electric motor input shaft and intermediate shaft. I see there are blue marks on the gears. Do shaft gears teeth have to align with one another or can I just place them in without aligning them specifically? I work on cars a lot but never on a transmission so I'm not sure where to go from here. All transmission shops near me are booked for a couple of weeks. Here is picture below of the gear's/shafts I'm talking about and the other is my snapped housing. If anyone has a link to manual or where I can purchase one that would be greatly appreciated. Thanks ahead.

Posted 11/10/15 on OASIS. Presumably this relates to CSP 14B07. TSB 15-0174 HF-35 TRANSMISSION FLUID LEAK AT DAMPER HOUSING TO TRANSMISSION CASE JOINT - RTV SEALANT FAILURE - BUILT ON OR BEFORE 12/1/2013 Publication Date: November 10, 2015 FORD: 2013 C-MAX 2013-2014 Fusion LINCOLN: 2013-2014 MKZ This article supersedes TSB 14-0085 to update the Service Procedure, Part List and Service Labor Time Standards. ISSUE:Some 2013 C-Max, 2013-2014 Fusion, MKZ Hybrid and Energi vehicles equipped with a HF-35 automatic transmission and built on or before 12/1/2013 may exhibit a transmission fluid leak at the damper housing to transmission case joint. This condition may be due to an adherence failure of the RTV. ACTION:Follow the Service Procedure steps to correct the condition. SERVICE PROCEDURE Remove the transmission from the vehicle and separate the damper housing from the transmission case. Refer to the Workshop Manual (WSM), Section 307-01.Use Motorcraft® Silicone Gasket Remover to remove old RTV from the housing and case mating surfaces. Allow to dry.Use Motorcraft® Metal Surface Prep Wipes to clean and etch the mating surfaces. Allow to dry.Apply a bead of Motorcraft® Ultra Silicone Sealant and reassemble the transmission. Refer to WSM, Section 307-01.Install the transmission. Refer to WSM, Section 307-01.