Leaderboard

Just a little info for everyone, Use it however you want. I spent 20yrs as an auditor for various gas stations/stores across the southeast USA. Part of that job was verifying the fuel level reporting of each station. Reports were used to track refill orders & to report to the EPA to verify tank & fuel pipes were not losing fuel [EPA does not care what leaks into tanks just what could leak out]. Despite appearances, gas stations are not sealed. Every time you put a gallon in your car, the same volume of air is drawn into the feed tank. Outside air with moisture & dust. I probably checked a thousand or more over the years & EVERYONE of them had some water/dirt in the bottom of the tanks. Depending on the size of tank & water level, equipment is used to remove excess. There is a reason for using fuel additives that should not ignored. THANKs for the read.

HALLELUJA!!!!!!! Thank you Lord. She runs! First try, it was a tad rough and low rpm(5-600-ish) for a couple seconds and slowly starting picking up rpm to the normal 1500. I waited another 15 seconds and floored it, went up to 2100 (how its always done) and back to 1500 when I let off. Put it in gear and moved it backward and forward a few feet (wife's car is in front). A minute later the rpm fluctuated up and down then went up to 2100 roughly like it was randomly dropping a cylinder then smoothed out and went back to 1500 smoothly, that scenario was maybe 10 seconds. Sat there another 2 minutes, still smooth, HVB already up to 50%. Set the defrost on max but lowest fan speed, to keep the ICE running. Going to let i run a half hour or so, get good and warm. Tomorrow I'll get it scanned. Ate something that didn't agree with me last night, don't feel like doing squat today, almost didn't even go out to try the car but it's warmed up to a balmy 18° so I figured to out. I'm guessing the problem was fuel related, something iced up or froze and maybe had some air in the lines causing that fluctuating/rough running for a few seconds just now.