Tom Posted May 20, 2021 Report Share Posted May 20, 2021 When the power went off in Texas could/did a hybrid owner plug into the C Max for house use? Quote Link to comment Share on other sites More sharing options...
fbov Posted May 20, 2021 Report Share Posted May 20, 2021 The plug in my C-Max was only good for 100W. It might charge your phone, but it can't start a refrigerator or run baseboard heaters. I've seen threads discussing more extreme measures, none of which I felt were advisable. Generators are cheap; my 4KVA runs the whole house, save 3-phase appliances. Quote Link to comment Share on other sites More sharing options...
cr08 Posted May 20, 2021 Report Share Posted May 20, 2021 As fbov said, the included inverter in the C-Max won't do much with just 100w capacity. In theory you can just get an aftermarket inverter to use in these cases but as always this is at your own risk. If doing so, keep in mind the DC-DC converter in our vehicles (takes place of a traditional alternator) is only capable of 120-130amp output capacity at 12v and this load is shared with all the other components in the vehicle (all computer modules, lighting, radio, etc..). If it were me (and I have considered this just for the VERY rare occasion I may need it in this neck of the woods if just to occasionally run the fridge if needed) I probably wouldn't go much higher than an 80 amp load which means an 800w (at 110/120v) continuous rated inverter tops. And also NEVER use an accessory outlet for this purpose and always attach directly to the battery if at all possible. As an additional note if this route is pursued, keep in mind the DC-DC converter is an EXPENSIVE replacement compared to a traditional alternator in case it fails. In theory an inverter should be a bit more stable of a load than, say, trying to jump start another vehicle (which is highly advised against for this reason, even if Ford doesn't explicitly call it out in their manuals), there's always that added risk with aftermarket components. Quote Link to comment Share on other sites More sharing options...
homestead Posted May 20, 2021 Report Share Posted May 20, 2021 (edited) I connected an additional 600W PSW inverter to my c-max 12v battery so I could run our pellet stove in case of a power failure. Tested it out and it worked fine. Never used it in an actual emergency. Then last year I moved the inverter to our truck camper which has dual 12v deep cycle batteries and used that during a 2-day power failure about the same time as the texas power failures. The camper setup worked well by running our stove overnight and then I would fire up our generator during the day to recharge the batteries. If we have an extended power failure I might try connecting the inverter back into the c-max. Edited May 20, 2021 by homestead Quote Link to comment Share on other sites More sharing options...
Duken4evr Posted December 24, 2021 Report Share Posted December 24, 2021 Ford's new F-150, hybrid, with an optional upgrade, has the ability to provide 7.6 kWh of power from it's gas engine. I find that even more interesting the the EV version offering even more power. The hybrid model is basically a rolling generator - could be great for contractors and campers, or power outages. Quote Link to comment Share on other sites More sharing options...
cr08 Posted December 24, 2021 Report Share Posted December 24, 2021 On 12/24/2021 at 3:19 PM, Duken4evr said: Ford's new F-150, hybrid, with an optional upgrade, has the ability to provide 7.6 kWh of power from it's gas engine. I find that even more interesting the the EV version offering even more power. The hybrid model is basically a rolling generator - could be great for contractors and campers, or power outages. The hybrids are able to take advantage of the higher voltage of the hybrid system and battery and this is where they're pulling power from for the inverter. The engine's able to provide a lot of power through the hybrid system. The F-150 hybrid motor/generator (a single motor compared to the dual motors used in eCVTs) is rated for 47hp/35kw. In comparison, trying to do that off the 12v side is going to be a MASSIVE undertaking due to the amount of amps involved. 7200w/12v is 600 amps. The HVB likely has a nonminal voltage of around 300v. That's 7200/300 = just 24 amps. BIG difference. fbov 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.