Leaderboard

1 mark wiper positions 2 remove wiper arms 15 mm 3 remove cowl 4 screws with torques bit. Start at corner at windshield and pry up cowl with your fingers. 4 remove cowl holding plate. 10mm and 2 torques screws (hint remove after removing engine cover. Leaving this loose makes it easier to remove engine cover) 5 remove engine cover 7mm 8mm (YouTube it if unsure of this step’s procedure) 6 locate ECT Sensor (back side of engine passenger side. 7 place shop rags under sensor. Carefully pry up clip holding it so it doesn’t fall into the abis. Note it’s position. It slides back in very easily when correctly done so. 8 remove sensor by pulling 9 reverse order to put everything back together (I put a dab of plumber’s silicone on O-ring to make it slide in easily. A dab of dish detergent will work also.) Note: I also replaced air filter while engine cover was off.

1 mark wiper positions 2 remove wiper arms 15 mm 3 remove cowl 4 screws with torques bit. Start at corner at windshield and pry up cowl with your fingers. 4 remove cowl holding plate. 10mm and 2 torques screws (hint remove after removing engine cover. Leaving this loose makes it easier to remove engine cover) 5 remove engine cover 7mm 8mm (YouTube it if unsure of this step’s procedure) 6 locate ECT Sensor (back side of engine passenger side. 7 place shop rags under sensor. Carefully pry up clip holding it so it doesn’t fall into the abis. Note it’s position. It slides back in very easily when correctly done so. 8 remove sensor by pulling 9 reverse order to put everything back together (I put a dab of plumber’s silicone on O-ring to make it slide in easily. A dab of dish detergent will work also.)