bobmaxed Posted May 29, 2014 Report Share Posted May 29, 2014 I have a 2014 C-Max hybrid. I have always done my own oil changes and see no reason to stop now. I would like to hear from owners who have done their own c-max oil changes. It looks like it'll be easier if I use my ramps. I suspect the underbody tray must come off. How hard is that? Are the filter and drain plug easy to find? Any special issues? ThanksBob Holada Quote Link to comment Share on other sites More sharing options...
homestead Posted May 29, 2014 Report Share Posted May 29, 2014 I just changed our oil after 1yr and about 8k miles. It wasn't too bad. My ramps didn't work until I jacked the passenger side of the carand then I slipped the ramps halfway under the front tire and 1/3 of the way under the rear. Then I lowered the jack some so the tires werepartially resting on both ramps on just the passenger side of the car, like giant wheel chocks to make it safe to crawl under the car.The underbody tray came off and back on easy. Go for it. Quote Link to comment Share on other sites More sharing options...
fotomoto Posted May 29, 2014 Report Share Posted May 29, 2014 Yes, you'll have to remove the under tray. It's rather large and has numerous screws. That's the most difficult part of the job actually. You'll need low rise ramps if you don't have them all ready. The filter and oil drain plug are easy to spot and get to. Quote Link to comment Share on other sites More sharing options...
plus 3 golfer Posted May 29, 2014 Report Share Posted May 29, 2014 I have a 2014 C-Max hybrid. I have always done my own oil changes and see no reason to stop now. I would like to hear from owners who have done their own c-max oil changes. It looks like it'll be easier if I use my ramps. I suspect the underbody tray must come off. How hard is that? Are the filter and drain plug easy to find? Any special issues? ThanksBob HoladaUse ramps. Tray comes off. Maybe 1/2 dozen screws. Filter and plug easy to get at. No special issues. Walmart usually stocks the correct motorcraft filter and Mobil 1 0W20 AFE oil In 5 quart jug. Less than $30 total. Quote Link to comment Share on other sites More sharing options...
JAZ Posted May 29, 2014 Report Share Posted May 29, 2014 Reprint from Hatchman: 1. Torx bit is a T-30, and as stated above, the drain plug is 15mm. I was able to reach the drain plug with a regular Craftsman 6 point socket and wrench, though it is a little tight. 2. Oil filter, can't miss it, right on the bottom, middle, forward, of the engine. Not a lot of room around it, but able to get the wrench on it. They must have had a 500 pound gorilla tightening oil filters the day this car was made. YMMV. 3. Out of the 8 torx screws, the two longest ones go to the outside. The three in the front and three in the back are shorter. Don't over tighten, they are just held by plastic "nuts" and will strip. There is a thick metal tab towards the rear which will help support the underbody panel while you're installing it; make sure it's engaged. Lastly, remember to reset the Oil Life Monitor (procedure found in this forum or in your Owners Manual). scottwood2 and hybridbear 2 Quote Link to comment Share on other sites More sharing options...
BIG ROCCO Posted May 30, 2014 Report Share Posted May 30, 2014 I got rid of my ramps 20+ years ago - I used a floor jack to jack up one side at the jacking point on the rocker panel just behind the front wheel arch. I inserted a small/low Harbor Freight jack stand and then did the same on the other side. Very easy and very stable and safe. Quote Link to comment Share on other sites More sharing options...
scottwood2 Posted August 5, 2014 Report Share Posted August 5, 2014 I heard someone say that Ford recommends to disconnect the battery before an oil change. Anyone heard of this? Anything else special to do this? What do you do to start the engine after the oil change to make sure there are no leaks? Turn on the heat? Quote Link to comment Share on other sites More sharing options...
Adrian_L Posted August 5, 2014 Report Share Posted August 5, 2014 I heard someone say that Ford recommends to disconnect the battery before an oil change. Anyone heard of this? Anything else special to do this? What do you do to start the engine after the oil change to make sure there are no leaks? Turn on the heat? I can't see why they would recommend that. Unless you have kids playing inside the car, with the keys.... Putting her in neutral and stepping on the gas pedal would enagage the ICE, no? About twenty years ago, I forgot to put the oil pan bolt back in, but fortunately I noticed the puddle of oil before turning the key. Quote Link to comment Share on other sites More sharing options...
drdiesel1 Posted August 6, 2014 Report Share Posted August 6, 2014 (edited) I heard someone say that Ford recommends to disconnect the battery before an oil change. Anyone heard of this? Anything else special to do this? What do you do to start the engine after the oil change to make sure there are no leaks? Turn on the heat? Whomever you heard that from is WRONG. To start the ICE, just push the accelerator pedal to WFOand it will fire up. Edited August 6, 2014 by drdiesel1 Quote Link to comment Share on other sites More sharing options...
wab Posted August 6, 2014 Report Share Posted August 6, 2014 (edited) Quote"What do you do to start the engine after the oil change to make sure there are no leaks? Turn on the heat? " The only way I've been able to start ours when we are towing (per the manual you're supposed to run the motor every couple of hours) is to turn the AC on and let it run on the HV battery, pretty soon the ICE will start.This is what I do when changing the oil. Edited August 6, 2014 by wab JAZ 1 Quote Link to comment Share on other sites More sharing options...
scottwood2 Posted August 6, 2014 Report Share Posted August 6, 2014 Quote"What do you do to start the engine after the oil change to make sure there are no leaks? Turn on the heat? " The only way I've been able to start ours when we are towing (per the manual you're supposed to run the motor every couple of hours) is to turn the AC on and let it run on the HV battery, pretty soon the ICE will start.This is what I do when changing the oil.Thx for the reply. Interesting, With the A/C being electric I thought it would take a while for the ICE to come on or does it draw so much power that it drains the battery down enough to have to recharge it? Quote Link to comment Share on other sites More sharing options...
fotomoto Posted August 6, 2014 Report Share Posted August 6, 2014 Thx for the reply. Interesting, With the A/C being electric I thought it would take a while for the ICE to come on or does it draw so much power that it drains the battery down enough to have to recharge it? Yes, that method would take a loooooong time. With car on and in Park, simply press the accelerator to the floor and the ICE will start and continue to run through its warmup program (or until you turn the car off) which is more than enough time to get out and check for leaks and get a proper reading on the dipstick. Quote Link to comment Share on other sites More sharing options...
wab Posted August 6, 2014 Report Share Posted August 6, 2014 Thx for the reply. Interesting, With the A/C being electric I thought it would take a while for the ICE to come on or does it draw so much power that it drains the battery down enough to have to recharge it? If you use EV+ and are home the HV battery will be pretty low, sometimes ours is very low, it doesn't take long.When we're towing and the HV is charged :waiting: I start turning everything on. Quote Link to comment Share on other sites More sharing options...
drdiesel1 Posted August 6, 2014 Report Share Posted August 6, 2014 (edited) ^^^^^ A proper reading on the dipstick can only be attained after the ICE has been off long enoughto allow the oil to drain back into the oil pan. When checking oil level, it's best to check after sittingfor a few hours. You can get a general level by wiping the stick when the engine is shut down,but the best way to be sure would be after parked overnight ;) Pull the stick out and read it :rockon: Edited August 6, 2014 by drdiesel1 Quote Link to comment Share on other sites More sharing options...
Adrian_L Posted August 6, 2014 Report Share Posted August 6, 2014 Overnight? Why? So the oil level on the dipstick rises by 1/32nd of an inch to its "correct" level?! Why would you need such precision? You can get a reasonably accurate dipstick reading after being parked on level ground for 10-15 minutes. Quote Link to comment Share on other sites More sharing options...
fotomoto Posted August 6, 2014 Report Share Posted August 6, 2014 Pg 280 of the OM: ENGINE OIL CHECK A. MIN B. MAX Note: Check the level before starting the engine. Note: Make sure that the level is between the MIN and MAX marks. 1. Make sure that your vehicle is on level ground. 2. Turn the engine off and wait 10 minutes for the oil to drain into the oil pan. 3. Remove the dipstick and wipe it with a clean, lint-free cloth. Replace the dipstick and remove it again to check the oil level. If the level is at the MIN mark, add oil immediately. Quote Link to comment Share on other sites More sharing options...
scottwood2 Posted May 25, 2015 Report Share Posted May 25, 2015 Just did the oil change today. It went well. Did find out that starting the car while holding down the gas pedal will only start the car for about 5 seconds. I found out that I can hold down the brake and the throttle and it will stay running. Quote Link to comment Share on other sites More sharing options...
rjam Posted May 28, 2015 Report Share Posted May 28, 2015 Hi. Am I missing something here. Why do it yourself. Go to Ford site and find this coupon:THE WORKS™ VEHICLE CHECKUP, $39.95 or less.• Synthetic Blend Oil Change• Tire Rotation and Pressure Check• Brake Inspection• Multi-Point Inspection• Fluid Top-Off• Battery Test• Filter Check• Belts and Hoses Check Up to five quarts of Motorcraft® oil and oil filter. Taxes, diesel vehicles and disposal fees extra. Hybrid battery test excluded. See participating dealership for exclusions and details. So tire rotation and all the other extras for less than $39. When I had the last oil change they saw seepage but didn't know from where so they added the dye. No charge and I have 48K on the car. Took it back a couple weeks later and they checked the dye and found it was rear seal. Gave me a loaner. No charge. Replaced the rear main seal. No charge and gave me a free car wash. Changing my own makes no sense for me. :) Quote Link to comment Share on other sites More sharing options...
Robert Fugate Posted May 28, 2015 Report Share Posted May 28, 2015 It sounds like a great deal, if it's done right and they don't try to sabotage your car! There's been times of oil plugs stripped, over torque/stripped/broken bolts on the wheels causing warped rims & rotors. Something so simple, if you have the correct tools it can be a piece of cake. Plus the satisfaction of doing it right, cheaper, and in less time! wab, Cuzmanj and Noah Harbinger 3 Quote Link to comment Share on other sites More sharing options...
plus 3 golfer Posted May 28, 2015 Report Share Posted May 28, 2015 It sounds like a great deal, if it's done right and they don't try to sabotage your car! There's been times of oil plugs stripped, over torque/stripped/broken bolts on the wheels causing warped rims & rotors. Something so simple, if you have the correct tools it can be a piece of cake. Plus the satisfaction of doing it right, cheaper, and in less time! +1 I've also had small dents in my cars after dealer service. Problem is I didn't notice them until a day or so later. It happened on my 2009 Jetta and most recently on my C-Max after my January 2015 trip to the dealer for a recall. The 3 yr / 36 k free maintenance on my 2009 Jetta TDI likely wasn't "free". ;) They gave me an extra dent that likely affected trade-in value. Robert Fugate 1 Quote Link to comment Share on other sites More sharing options...
timwil56 Posted May 31, 2015 Report Share Posted May 31, 2015 There's always a lot of opinions and heated discussion when it comes to oil and oil changes, so I'll add mine.Every 12 months, regardless of ICE mileage. I drive 75% EV and 25% ICE.Mobil 1 0-20Motorcraft FL-910SDrive car with ICE for 10-20 miles to heat oilDrain for 30 minutes, rocking the car a couple of times after it's drainedRunning ICE for a couple of minutes to check for leaks, waiting 10-15 minutes and checking level.First thing in the morning, pulling dipstick and re-checking level iadubber 1 Quote Link to comment Share on other sites More sharing options...
jackalopetx Posted November 16, 2016 Report Share Posted November 16, 2016 (edited) Just did the oil change today. It went well. Did find out that starting the car while holding down the gas pedal will only start the car for about 5 seconds. I found out that I can hold down the brake and the throttle and it will stay running. Wait so you guys are redlining your engines on cold oil to "check for leaks"? Seems like the low chance of an undiscovered leak is not worth harming your engine. And why would leaks only start after changing the oil? Edited November 16, 2016 by jackalopetx Quote Link to comment Share on other sites More sharing options...
Louder North Posted November 17, 2016 Report Share Posted November 17, 2016 Wait so you guys are redlining your engines on cold oil to "check for leaks"? Seems like the low chance of an undiscovered leak is not worth harming your engine. And why would leaks only start after changing the oil? I'm sure there was a missed 'then fill with the correct oil in the correct amount' step that was missed in that sequence.... Quote Link to comment Share on other sites More sharing options...
fbov Posted November 18, 2016 Report Share Posted November 18, 2016 (edited) Wait so you guys are redlining your engines on cold oil to "check for leaks"? ...No. We're telling a control system to turn on the engine. It's not a cable to the throttle.Frank Edited November 18, 2016 by fbov Quote Link to comment Share on other sites More sharing options...
ptjones Posted November 18, 2016 Report Share Posted November 18, 2016 Just sent off my third oil change sample with 14K ICE miles on it to Blackstone Labs to be evaluated. 141k miles total, oil level still above low level mark. :) Paul Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.